Instruction manual

MERLIN LEGEND Communications System Release 5.0

System Planning

555-650-112

Issue 1

June 1997

Lines/Trunks

Page 3-57Assigning Telephone Buttons

c. Assign programmed Loudspeaker Paging buttons by selecting the

button and writing Page on it.

Direct-Line Consoles 3

Use these instructions only if the system has one or more DLCs. Otherwise,

proceed to Chapter 4, ‘‘

Features’’, to record feature assignments on the forms for

each extension.

NOTE:NOTE:NOTE:

For more information on DLCs, see the

Feature Reference

The number of line, Direct Station Selector (DSS), and programmed feature

buttons assigned to a DLC depends on the type of telephone and the number of

lines/trunks connected to the system. The factory setting for DLCs is that, in

addition to an SA Voice and an SA Ring button or ICOM buttons, as many

lines/trunks as possible are assigned to each console. Each line/trunk appears on

a separate button, which means that the number of lines/trunks assigned is limited

to the number of buttons on the console (up to a maximum of 32 buttons on the

34-button analog DLC).

If a DSS is present, the system assigns a DSS button for each extension number

associated with an extension and special-feature buttons that are used by the

DLC operator for call-handling functions.

Figures3-6

and 3-7 show initial line/trunk and feature assignments for MLX and

analog DLC consoles. Refer to the appropriate figure as you select line/trunk

assignments for DLCs.

NOTE:NOTE:NOTE:

System Access buttons appear on DLCs in Hybrid/PBX mode. Intercom

buttons appear on DLCs in Key or Behind Switch mode.