Instruction manual

Features
Message Waiting Receiver
Message Waiting Receiver allows you to designate a telephone to receive
message-waiting indications for the group. The message receiver for a calling
group does not have to be a member of the group.
Each calling group can have only one telephone assigned as its message
receiver. The same telephone can be assigned as the message receiver for
more than one calling group.
Planning Form Instructions
Under the "Message Waiting Receiver" heading on Form 6e, do one of the
following:
■
Check "No" if you are not assigning a receiver.
■
Check the second box if assigning a receiver. Write the extension number
of the Message Waiting Receiver. (Refer to Form 2a).
Calls-in-Queue Alarm
Calls-in-Queue Alarm Threshold allows you to set the limit for the number of
Threshold
unanswered calls that wait in the calling group queue before group members
are notified. Once the threshold is reached, group members are notified with a
See "External Alert for Calls-in-Queue
light on the telephone and an external alert if one is assigned.
Alarm" that follows.
The factory-set threshold is 1 call. You can change the number of calls to up to
99 calls.
Planning Form Instructions
Under the "Calls-in-Queue Alarm Threshold" heading on Form 6e, do one of
the following:
■
Check "1 Call" to keep the factory setting.
■
Check the second box to change the factory set number of calls allowed
in the queue before members are notified. Write the number of calls in the
space provided.
External Alert for Calls-in-
External Alert for Calls-in-Queue Alarm allows group members to be notified by
Queue Alarm
an external alert when calls waiting in the queue are equal to or greater than the
programmed threshold. The alerting signal remains active until the number of
calls in the queue drops below the threshold.
Note: Since the signal is continuous, it is recommended that only lamp-type
external alerting devices be used.
The external alert designated for Calls-in-Queue Alarm can be any alerting
device connected through a Multi-Function Module (MFM) in the External Alert
mode for digital/lSDN (MLX) telephones. Only one external alert can be
designated for each calling group.
Note: An alert connected to a Supplemental Alert Adapter (SAA) for an analog
multiline telephone should not be used as a Calls-in-Queue Alarm.
Group Assigned Features 4-17