Instruction manual

Training
Table 7–3, Continued
To Learn About Programming . . . Check This Guide . . .
Lines and Trunks (continued)
Changing the channels for T1 DS1 service Consult your AT&T representative and
System Programming, Chapter 4.
Changing settings for PRI or NI-1 BRI service Consult your AT&T representative and
network service provider.
Changing the way malfunctioning trunks are taken out
of service
Consult your AT&T representative and see
System Programming, Chapter 4.
Feature Reference. See “Automatic
Maintenance Busy.”
Setting up Remote Access trunks Feature Reference . See “Remote Access.”
System Programming , Chapter 4
Changing Automatic Route Selection (ARS) Facility
Restriction Levels for lines/trunks
System Programming, Chapter 4
Feature Reference. See “Automatic Route
Selection.”
Changing settings for DID or tie lines Consult your AT&T representative.
Assigning trunks to pools System Programming, Chapter 4
Feature Reference . See “Pools.”
Training
When your system is set up and installed, your AT&T representative provides
training on how to use and manage the system.
In addition, training videotapes are available from AT&T. The videotapes are
designed to provide only an overview and are not intended to provide
comprehensive information. For detailed, comprehensive information, refer to
the system guides.
For more information about training, contact your AT&T representative.
Learning More
7–21