Instruction manual

System Guides Information Finder
Table 7–2, Continued
To Learn About These Features . . . Check This Guide . . .
System Management
Using and understanding memory cards System Programming, Chapter 3 and 4
Backing up programming, automatically or manually System Programming, Chapter 3
Understanding backup messages System Programming, Chapter 3
Changing the language in which reports are printed System Programming, Chapter 3
Getting reports System Programming, Chapter 3
Setting up your system to work with the Integrated
Administration feature of the Integrated Solutions
application
Consult your AT&T representative and see
System Programming, Chapter 4, and
Feature Reference , “Integrated
Administration.”
Table 7–3. Information Finder: Programming
To Learn About Programming . . . Check This Guide . . .
Systemwide Basics
Finding out the modes of operation in which a
systemwide feature is available
Feature Reference, Appendix C
Changing the system’s mode of operation Consult your AT&T representative and
System Programming , Chapter 4
Changing the system programming position System Programming, Chapter 3
Changing the system date and time System Programming, Chapter 3
Changing the system language System Programming, Chapter 3
Changing the system’s numbering of lines and
extensions
Consult your AT&T representative and
System Programming , Chapter 3
Changing DSS buttons when you renumber the system System Programming, Chapter 4
Setting up operator positions System Programming, Chapter 3
Turning One-Touch Transfer or One-Touch Hold on or
off
System Programming, Chapter 4
Changing the timing for the return to the originator of
transferred, parked, or camped-on calls when the
destination extension remains busy
System Programming, Chapter 4
Changing what a caller hears when being transferred System Programming, Chapter 4
Changing the number of rings for the Delay Ring
setting
System Programming, Chapter 4
Continued on next page
Learning More
7–17