Instruction manual

Adding/Removing a Line
—
Form 5d, Queued Call Console (QCC)
—
Data Form 1a, Modem Data Station
—
Data Form 1b, 7500B Data Station
o If necessary, read “Trunk-to-Trunk Transfers in the Feature Reference for
detailed information about this feature.
o Plan changes and record the new values on the form(s).
o Open the System Programming menu from the console or a PC with SPM.
o Program the change(s), following the instructions for “
Trunk-to-Trunk
Transfer”
in System Programming , Chapter 3, or the summary
programming instructions below.
o When you have finished, file the form(s) with the rest of the planning
forms.
Programming Instructions
Console Procedure:
→More→More→ →
Toggle LED On/Off or Dial ext. no.→ →
→
PC Procedure:
6
→u→7→Toggle letter On/Off or Type
ext. no.
→0→5→5
Adding/Removing a Line
Use this procedure to add a line to or remove a line from the system.
Planning Guidelines
If you are adding a new line and need to order a module to connect the line,
coordinate the installation and connection dates to ensure that the new module
is installed before the line is connected to the system.
Task List: Adding/Removing a Line
o Obtain Form 2c, System Numbering: Line/Trunk Jacks. Check the form to
confirm that there is a spare jack.
NOTE:
If you are adding a line but there is no spare jack, you need to add a new
module. Contact your AT&T representative.
o Contact your central office (CO) to obtain a new line or to disconnect a
line.
Managing the System
6–47