Instruction manual

Centralized Telephone Programming
Console/Display Instructions Additional Information
3 Select a programming option.
_
Select or
1
_
.
2
4 Go to either “Guidelines for Programming Extensions,” “Copying Feature and
SA/ICOM Buttons,” or “Copying Line/Trunk Button Assignments.”
The following sections explain the use of menu selections for programming a
single extension, and for using the feature and SA/ICOM buttons and/or the
line/trunk button assignments of one extension as a template for programming
several extensions of the same type. For information about copying calling
restrictions from one extension to another, see “Copy Call Restrictions” in
Chapter 3 of
System Programming .
NOTE:
You should use programming codes for centralized telephone programming;
however, you may also use the
option that is available on the
programming screen for extensions as described in the next section. For
detailed information about the
option, see Chapter 5 in System
Programming
.
Guidelines for Programming Extensions
Review the items below before you begin to program extensions.
■
Refer to Appendix C in System Programming to locate the code for the
feature that you want to program, or use the List Feature menu (which
includes the
option) by selecting from the
screen that appears when you are programming a feature (see Step 6 in
the following procedure). For more information about using the List
Feature menu, see Chapter 5 in
System Programming .
■
If you enter a feature code incorrectly or enter a feature code that is not
appropriate for the selected button, you may hear a beep or see the
message
as the green light next to the button
flashes. Press the button again and repeat the procedure.
■
If you program the wrong feature on a button, follow the steps below:
1. Press the button.
2. Select
(press 2 on the PC).
3. Press the button again.
6–24 Managing the System