User`s guide

8 Dial the extension number where the caller will be connected.
9 Dial ##.
The two-beep confirmation tone sounds.
10 Continue programming or exit authorized caller mode by dialing *#.
11 To disconnect, dial #.
Erasing an Existing Route
If you need to eliminate a route you previously programmed, follow the
procedure below:
1
2
3
4
5
6
7
8
9
10
Dial the MERLIN II Attendant extension number from a Touch-Tone
phone, preferably a single-line set.
NOTE: If you are programming from a multiline Touch-Tone phone
connected to a MERLIN II system control unit, you must enter an
additional pound ( # ) sign each time a pound ( # ) sign appears in
a programming command,
Wait for an answer.
Dial * followed immediately by your authorized caller code and #.
The two-beep confirmation tone sounds.
Dial *8.
Dial the route number (0 through 9) you want to erase.
Dial the extension code of the
11 =
12 =
21 =
22 =
route you want to erase.
Day Primary Extension
Day Secondary Extension
Night Primary Extension
Night Secondary Extension
Dial 0, the transfer code for “No Operation. ”
Dial ##.
The two-beep confirmation tone sounds.
Continue programming or exit authorized caller mode by dialing * #.
To disconnect, dial #.
Programming a New Route for Blind Transfer
To program a blind transfer, refer to Planning Form G and follow the steps
below:
1 Dial the MERLIN II Attendant extension number from a Touch-Tone
phone, preferably a single-line set.
NOTE: If you are programming from a multiline Touch-Tone phone
connected to a MERLIN II system control unit, you must enter an
additional pound ( # ) sign each time a pound ( # ) sign appears in
a programming command.
2 Wait for an answer.
3 Dial * followed immediately by your authorized caller code and #.
The two-beep confirmation tone sounds.
2-10 Changing the Current Settings