Programming instructions

MERLIN LEGEND Planning
MERLIN LEGEND Form 2c:
System Numbering—Trunk Jacks
Use MERLIN LEGEND Form 2C to verify that loop-start lines on the MERLIN
LEGEND system are set to “reliable.” Loop-start lines must be set to “reliable” so
that calls will be properly disconnected.
➀ Loop-Start Reliable Disconnect
Verify that the “Yes” box is checked, indicating you have loop-start lines
(LS) that have a reliable disconnect signal.
PBX System Form 2
C
System Numbering — Trunk Jacks
Music-on-Hold, Logical ID
Source
Maintenance Alarm, Logical ID
Loudspeaker Page, Logical lD
Loop-Start Reliable Disconnect
❑ No ✦ ❑ Yes
✓
➀
Toll Prefix
QCC
Outmode
Not
Short Hold
Operator QCC
Jack Type Trunk Type
Rotary Needed for Disconnect
to
Queue
(LS,GS,
(Basic LS, Dial LD Interval Receive Priority
Logical DID,Tie, Trunk
Basic GS, Telephone Numbs
Calls Level
ID DS1) Number
WATS,FX, ets.)
or Equipment
Yes
No ✦ Yes No ✦
Yes No ✦
(No ✦ ) (4 ✦ )
1
801
2
802
3
803
4
804
5 805
6
806
7
807
8
808
9
809
Figure 2-2. MERLIN LEGEND Form 2c
2-4 MERLIN LEGEND Form 2c