Instruction manual

Features
At a Glance (continued)
System Programming
Specify the FRL and/or digits that must be added when people
continued
dial emergency numbers in the Special Numbers (N11) table:
● Tables → ARS → More → SpeclNumber →
ARS FRL/ARS Digit
Specify the pool routing, FRL, and digits or special characters
that must be added by the system to the number dialed by the
user when calls are routed on the Dial 0 table:
● Tables → ARS → More → Dial 0 →
ARS Pool/ARS FRL/ARS Digits
Specify whether a route is to be used for voice, data, or both on
a PRI call:
● Tables → More → Sub A Data/Sub B Data
Allow or restrict Remote Access users (without barrier codes)
from using selected trunks:
● Lines Trunks → RemoteAccss →
Non-TIE/TIE Lines → ARS Restrct
Allow or restrict Remote Access users (with barrier codes) from
using selected trunks:
● Lines Trunks → RemoteAccss → BarrierCode
→ ARS Restrct
Assign or restrict extensions from using selected trunks:
● Extensions → ARS Restrct
Maximums
Programmable
16 (1-16)
Routing Tables
Entries per table
100
Factory-set tables
4 — Dial 0 (table 19), Special Numbers (N11, table 20),
Default Toll (table 17), Default Local (table 18)
Subpatterns
2 per programmable table
Routes
6 (1-6) per subpattern
Absorbed digits
11 (0-11) per route
Pre-pended (added)
20 (0-9, *, and Pause) per route
characters
Continued on next page
Automatic Route Selection 47