Instruction manual

Features
Table 2 shows the factory-set ALS sequence for each kind of telephone by
system operating mode. When Ringing/Idle Line Preference is on, buttons are
selected in the numbered order shown. For multiline telephones (including
operator consoles), the factory-set sequence begins with the lower left-hand
button of the type indicated, moves upward in the first column, moves to the
bottom of the next column to the right (if necessary), and moves upward to the
maximum of eight buttons. Where outside line buttons are included in the
sequence, they are selected in numeric order (by default, 801, 802, . . .), up to
the maximum number of lines shown.
Table 2. Factory-Set Automatic Line Selection Sequence
Mode
Telephone
Hybrid/PBX Key
Behind Switch
Multiline
3. SA O
3. Line 3
8. Line 8 1. Prime Line
(MLX or 2. SA V 2. Line 2 7. Line 7
Analog) 1. SA R 1. Line 1 6. Line 6
5. Line 5
4. Line 4
Single-Line
3. SA O
2. ICOM R
1. Prime Line
2. SA R 1. ICOM R
1. SA R
Direct-Line
5. Line 3
3. Line 3
8. Line 8
3. Line 3
8. Line 8
Consoles
4. Line 2
2. Line 2
7. Line 7
2. Line 2 7. Line 7
(MLX or 3. Line 1 8. Line 6 1. Line 1
6. Line 6 1. Prime Line 6. Line 6
Analog)
2. SA V 7. Line 5
5. Line 5
5. Line 5
1. SA R 6. Line4 4. Line 4
4. Line 4
Queued Call 5. Call 5
Console
4. Call 4
3. Call 3
2. Call 2
1. Call 1
SA R, ICOM R
= SA Ring, ICOM Ring
SA V, ICOM V = SA Voice, ICOM Voice
SA O, ICOM O
= SA Originate Only, ICOM Originate Only
Considerations and Constraints
Outside line buttons and SA or ICOM buttons can be included in the ALS
sequence. However, inside and outside lines should not be interleaved. A
typical sequence would consist of all desired SA or ICOM buttons, followed by
all desired outside line buttons.
40
Automatic Line Selection and Ringing/Idle Line Preference