Instruction manual

Programming Special Characters
MLX-10 Non-Display Telephone
Some dialing sequences need special characters. For example, the user would
press Hold to insert a Pause (p) after the dial-out code in a dialing sequence to
allow the system to seize an outside line before dialing the number. A Pause
can also be used to separate a telephone number from an extension number.
Table G-3. Special Characters for MLX Non-Display Telephone
Press...
Means...
Drop Stop. Halts the dialing sequence to allow the system to respond.
Hold
Pause. Inserts a 1.5-second pause in the dialing sequence. Multiple
consecutive pauses are allowed.
Conf
Flash. Sends a switchhook flash. Must be the first entry in the dialing
sequence.
##
End of Dialing for extension programming only. Used at the end of a
dialing sequence to indicate the user has finished dialing or to separate
one group of dialed digits from another, such as an Account Code from
a telephone number.
#
End of Dialing. Used to signal the end of the dialing sequence or to
separate one group of dialed digits from another, such as an Account
Code from a telephone number.
MLX-10 Non-Display Telephone G-3