Instruction manual

General Feature Use and Telephone Programming
Table C-2. Programming Analog Multiline Telephones
Step
Action
1 Label the button.
■ Remove the clear label cover from the
Note: Skip this step if the
feature will not be programmed
onto a button.
2
Begin programming.
3 Select the feature.
4 End programming.
telephone by the inserting the end of a
paper clip in the notch at the top of the
cover.
■ Write the feature name on the card next
to the button to be programmed.
■ Replace the cover.
■ Slide the T/P switch on the side of the
telephone to P.
■ Press the button you labeled.
If you have a display, it shows the name
of the feature currently programmed on
the button. If no feature is
programmed, the display indicates that
the button is blank.
Note: If the feature does not get
programmed onto a button, press any
line button. This does not affect the
button in any way.
Dial the programming code.
The feature is programmed.
■ Slide the T/P switch to the center
position.
Telephone Programming
C-17