Instruction manual

Features
Toll Type
At a Glance
Users Affected
Telephone users, operators
Reports Affected
General Trunk Information
Mode
All
Telephones
All
System Programming
Designate whether or not a toll prefix is required:
● LinesTrunks → Toll Type
Factory Setting
Toll prefix required
Description
Toll Type allows the system to classify calls as either local or toll, based on the
number a user dials. The factory setting for Toll Type requires the user to dial a
toll prefix (1 or 0) before dialing the area code and telephone number for a toll
call. In some areas, a toll prefix is not necessary. The factory setting for Toll
Type can be changed to specify that no toll prefix is required for these types of
trunks.
Dialing a prefix depends on local telephone company requirements and the
type of trunk being used.
Considerations and Constraints
Toll Type does not apply to tie trunks or Direct Inward Dialing (DID) trunks.
The local telephone company must be consulted to determine which of the
system’s trunks require a toll prefix.
Mode Differences
Hybrid/PBX
Systems that operate in the Hybrid/PBX mode and have Automatic Route
Selection (ARS) always require the user to dial 1 before dialing a 10-digit toll
call. Some 7-digit numbers may require dialing 1 as well.
Toll Type
479