Instruction manual

Features
Table 35- Continued
Extensions
Renumbering
Yes or No
Factory Settings
Operator (Primary
System or QCC)
Paging Groups
Park Zones
Pool
Remote Access
Code
Stations
Trunks
No
Yes
Yes
Yes
Yes
Yes
Yes
0
793-799
881-888 (system operator only)
Main Pool: 70
Dial-in Tie Trunk: 891
Automatic-in Tie Trunk: 892
889
10-67 (2-digit plan)
100-243 (3-digit plan)
801-880
Single Renumbering
Single Renumbering should be used any time the extension numbers you are
changing to or from are not sequential.
Single Renumbering can be used to assign a specified extension number to the
following: stations, adjuncts, trunks, telephones, Automatic Route Selection
Access Code, Calling Groups, Idle Line Access Code, Listed Directory Number,
Paging Groups, Park Zones, Pools, and Remote Access Code.
In Release 1.0, when you used Single Renumbering to assign a specified
extension number, the system was forced idle during the renumbering process.
In Release 1.1 and later, the system is not forced idle when you renumber
telephones, Automatic Route Selection Access Code, Calling Groups, Idle Line
Access Code, Listed Directory Number, Paging Groups, Park Zones, Pools, and
Remote Access Code. However, in Release 1.1 and later, when you renumber
a station, an adjunct, or a trunk, the individual facility you are renumbering is
forced idle during the renumbering process.
System Renumbering
475