Instruction manual

Features
Signal/Notify
At a Glance
Users Affected
Reports Affected
Mode
Telephones
Programming Code
Signal
Notify, Send
Notify, Receive
MLX Display Label
Signal
Notify, Send
Notify, Receive
Telephone users, operators
Extension Information
All
All except QCC and single-line telephones
*23 + ext. no.
*757 + ext. no.
*758 + ext. no.
Signal [Signl]
Notify,Send [Ntfy,Send]
Notify,Receive [Ntfy,Recv]
Description
A user can signal another telephone user without making a call to that
extension, using either the Signal feature, which beeps the destination
telephone, or using the Notify feature, which lights an LED on the destination
telephone. The meaning of the signal can be prearranged between the sending
and receiving users.
Signal
Using the Signal feature, a multiline telephone user can beep another
telephone. To use the feature, the user presses a programmed Signal button
without lifting the handset. A beep is heard at the destination telephone for as
long as the sender holds the button down.
In addition to sending a beep, the Signal button can be used to see the status
of the destination telephone. When the destination telephone user lifts the
handset or uses Do Not Disturb, the green LED next to the Signal button goes
on.
The user can also use the Signal button to dial the destination telephone
extension automatically. However, the user must select an SA or ICOM button
and either lift the handset or press the Speaker button before using the Signal
button; this is different from Auto Dial, which automatically selects a line and
activates the speakerphone.
Signal/Notify 441