Instruction manual

Features
Speed Dial
The Conf button is used to enter the Flash special character,
which simulates pressing the Recall button, in a Personal
Speed Dial or System Speed Dial telephone number.
System Access/ Recall can be used on a ringing or answered inside call made
Intercom Buttons on an SA or ICOM button, The call is disconnected and the
user hears internal dial tone. When the user is listening to a
busy signal, Recall has no effect.
Recall can be used by either the user with the principal SA
button or by the user with a Shared SA button who has joined
the call. In a Release 2.0 (or later) system, this includes an
outside call on a loop-start trunk that was made or received on
the SA or Shared SA button.
Transfer A single-line telephone user with a Recall button can use it to
transfer a call.
In a Release 2.0 (or later) system, Recall can be used on a
transferred outside call on a loop-start trunk, since the transfer
is received on an SA or ICOM button.
In Behind Switch mode, the fixed Transfer button on an MLX or
analog multiline telephone must be programmed through
system programming to send a timed flash plus the code
expected by the host switch to activate Transfer on the host. If
use of the communications system Transfer feature is also
desired, it must be programmed on an available line button on
each multiline telephone through extension programming or
centralized telephone programming.
Recall/Timed Flash 415