Instruction manual

Features
In Behind Switch mode, a Recall signal from a single-line telephone is ordinarily
sent to the host switch, since the factory setting for the Automatic Line Selection
(ALS) sequence selects the Prime Line. However, if the ALS sequence has
been changed to select an ICOM button and the user has used the Idle Line
Access code to initiate a call, the Recall signal accesses the communications
system’s Hold, Conference, and Transfer features, not those of the host switch.
NOTE:
■ If a single-line telephone with a timed disconnect is used, pressing
the switchhook disconnects the call. With this type of telephone, the
Recall button must be used instead of the switchhook for features
that require a switchhook flash.
■ Some single-line telephones have factory-imprinted Recall, Hold, or
Flash buttons that activate telephone features different from features
of the system. A single-line telephone user without a Recall button,
or with buttons that activate telephone-only features, must press and
release the switchhook to send a timed flash.
Feature Interactions
Allowed Lists,
Disallowed Lists,
and Calling
Restrictions
Auto Dial
Automatic Route
Selection
If Recall is used on a Personal Line or Pool button, or, in a
Release 2.0 (or later) system, on an SA or ICOM button used to
access an outside loop-start trunk, the accessed trunk is kept,
the user hears outside dial tone, and calling restrictions are
reapplied.
The Conf button is used to enter the Flash special character,
which simulates pressing the Recall button, in a telephone
number programmed on an Auto Dial button.
If Recall is used during an internal call made on an Auto Dial
button, the call is disconnected and the user hears internal dial
tone.
In a Release 2.0 (or later) system, Recall can be used on an
ARS call. Recall cannot be used during dialing. When dialing
is completed, pressing the Recall button sends a timed flash to
the host, the accessed trunk is kept, the user hears outside dial
tone, and calling restrictions are reapplied.
In a Release 1.0 or Release 1.1 system, Recall cannot be used
on an ARS call, since the call is made on an SA button.
412 Recall/Timed Flash