Instruction manual

Features

When used after dialing is completed on an outside trunk, Recall sends a timed

flash to the host switch, the trunk is kept, the user hears a new outside dial tone,

and calling restrictions are reapplied. On an ARS call or a call on a rotary-dial

trunk, Recall cannot be used until dialing is completed. On a call made using

the pool dial-out code, Recall can be used during, as well as after, dialing.

Considerations and Constraints

Recall can be used to send a timed flash to the host switch only on a loop-start

trunk.

The Recall button sends a switchhook flash. It is not a “redial” button.

Mode Differences

Hybrid/PBX Mode

In a Release 1.0 or Release 1.1 system, Recall cannot be used on any outside

call made or received on an SA button. In a Release 2.0 (or later) system, this

restriction is removed.

A Recall signal from a single-line telephone accesses the communications

system’s Hold, Conference, and Transfer features.

Key Mode

In a Release 1.0 or Release 1.1 system, Recall cannot be used on any outside

call made or received on an ICOM button. In a Release 2.0 (or later) system,

this restriction is removed.

A Recall signal from a single-line telephone accesses the communications

system’s Hold, Conference, and Transfer features.

Behind Switch Mode

If Recall is used on a call made or answered on the Prime Line, the timed flash

is sent to the host switch.

The fixed Conference, Drop, and Transfer buttons on an MLX or analog

multiline telephone must be programmed through system programming to send

a timed flash plus the code expected by the host to activate those features on

the host. Once this programming is done, these fixed buttons have no effect

when pressed during an internal call.

if use of the communications system Conference, Drop, and Transfer features is

also desired, they must be programmed on available line buttons on each

multiline telephone through extension programming or centralized telephone

programming. (These three options are not available in Hybrid/PBX or Key

mode.)

410 Recall/Timed Flash