Instruction manual

Features
HFAI
Paging
Personal Lines
Remote Access
Remote Call
Forward
SMDR
Transfer
Incoming calls on a line that is a member of a B-channel group
programmed for Routing by Dial Plan are not eligible for answer
by Hands-Free Answer on Intercom (HFAI).
If the routing endpoint of an incoming call matches a Group
Page access code, the call is routed to the endpoint
programmed for unassigned DID calls.
A Personal Line can be assigned to a telephone to represent a
PRI line with Routing by Dial Plan. The green LED associated
with the Personal Line lights steadily, and ringing on an SA
button occurs; the LED does not flash to indicate that a trunk is
ringing. Unlike DID, outside calls can be made on Personal
Lines.
A PRI line that has been programmed for Routing by Dial Plan
should not be programmed as Remote Access.
A PRI line that has been programmed for Routing by Dial Plan
cannot be programmed as belonging to a telephone with
Remote Call Forwarding allowed.
The trunk number of a PRI line is shown in the LINE field of the
SMDR. The authorization code for the FTS2000 network is
shown in the ACCOUNT field.
Call timing begins when the PRI line is selected. The Called
Number field shows the number dialed by the user, before any
digits are manipulated by ARS or PRI tables (Network Selection
Table, Special Services Selection Table, or Call-by-Call Services
Table).
If the SMDR feature is not enabled to record incoming calls, the
system does not accept Account Code Entry information for
these calls.
For a trunk-to-trunk transfer, if no station/extension number is
involved, the CPN for the outbound call is the programmed
base number.
372 Primary Rate Interface (PRI)