Instruction manual

Features
Routing by Dial Plan requires programming of the Dial Plan Routing Table and
the B-channel group to be routed by dial plan.
The Call Management System (CMS) does not support Routing by Dial Plan.
Display support for Routing by Dial Plan is on MLX telephones only.
If the end point number for an incoming call given Routing by Dial Plan
treatment is not found, the call is sent to the invalid destination number for DID
calls. This number can be a Dial Plan extension number or fast busy tone.
However, if it is fast busy tone, the call is rejected and the network applies
intercept tone.
A PRI line that has been programmed for Routing by Dial Plan should not be
programmed for Remote Access or Shared System Access.
Outgoing Calls
The outgoing telephone number that matches the digit pattern in the Network
Selection Table is deleted automatically. This is not programmable. The
common carrier ID is sent to the Foreign Exchange.
To specify that no telephone number is sent to the network, choose the Do not
Copy Phone Number programming option and be sure that no telephone
number is assigned to each channel in the B-channel group by using the
Telephone Number to Send procedure.
If ARS identifies a call as applying to a Call-by-Call B-channel group, but the
Call-by-Call Services table does not show a matching digit pattern and bearer
capability, the call is rejected.
Outgoing calls using Call-by-Call Selection Service can be made by pressing a
line button, pressing a pool button, dialing a trunk pool number, or via ARS.
The Call-by-Call Services Table must be programmed for the Call-by-Call
Service Selection feature to take effect. If a service is not specified in the table,
the entry is ignored.
Feature Interactions
Account Code An account code can be entered at a telephone on a PRI line
Entry
before the call is made or during the call. An account code
entered before a call is made will be treated as an authorization
code for all the outgoing calls placed over the PRI line.
If the SMDR feature is not enabled to record incoming calls, the
system does not accept Account Code Entry information for
these calls.
370 Primary Rate Interface (PRI)