Instruction manual

Features
At a Glance (continued)
System Programming
PRI (continued)
Specify telephone number to send to network for
outgoing calls on ISDN lines:
● LinesTrunks → PRI → NumbrToSend
Assign test trunk telephone number for each
100D module:
● LinesTrunks → PRI → Test TelNum
Set timer and counter thresholds for each
100D module:
● LinesTrunks → PRI → Protocol →
Timers
Assign link layer address or Terminal Equipment
Identifier (TEI) of equipment connected to each
D-channel:
● LinesTrunks → PRI → Protocol → TEI
Maximums
PRI modules
3
B-Channels
69
Lines (total)
72
Digits per telephone number
assigned to PRI channel
12
Lines per B-Channels group
23
Digits per telephone number sent
to network for outgoing calls
12
Digits for test trunk
telephone number
12
Dial Plan Routing Table
Number of entries 16 (0 through 15)
Digits per pattern
8
Digits to delete
14 (range 0-14, 0=wildcard)
Digits to add
4
Network Selection Table
Number of entries
4 (0 through 3)
Digits per pattern
8 (* = wildcard, at least one * required, all *s must
be at end and contiguous)
Special Services Selection Table
Number of entries
8 (0 through 7)
Digits per pattern
4
Digits to delete 4
Call-by-Call Services Table
Number of entries
10 (0 through 9)
Number of patterns per entry 10
Number of digits per pattern 8
Continued on next page
Primary Rate Interface (PRI)
349