Instruction manual

Features
Primary Rate Interface (PRI)
At a Glance
Users Affected
Telephone users, operators
Reports Affected
DS1 Information
PRI Information
SMDR
Mode
Key, Hybrid/PBX
Telephones
All (display support on MLX sets only)
System Programming
100D Module Specify type of facility connected to 100D module:
● LinesTrunks → LS/GS/DS1 → Type
Specify framing format for 100D module:
● LinesTrunks → LS/GS/DS1 → FrameFormat
Specify line coding for 100D module:
● LinesTrunks → LS/GS/DS1 → Suppression
Specify signaling for 100D module:
● LinesTrunks → LS/GS/DS1 → Signaling
Specify line compensation between 100D module and Channel
Service Unit (CSU) or far end:
● LinesTrunks → LS/GS/DS1 → Line Comp
Specify 100D modules that provide primary, secondary, and
tertiary clock synchronization and source of clock
synch ionization; also activate/deactivate clock:
● LinesTrunks → LS/GS/DS1 → ClockSync
Specify type of CSU equipment provided by CO:
● LinesTrunks → LS/GS/DS1 → Channel Unit
PRI Assign telephone number to PRI channel:
● LinesTrunks → PRI → Phone Number
Assign B-channels to group:
● LinesTrunks → PRI → B-ChannlGrp → B Channels
Specify type of outgoing network service for each B-channel group:
● LinesTrunks → PRI → B–ChannlGrp → NetworkServ
Specify telephone number to send to network for outgoing calls
(copy number received from network or use PRI channel telephone
number):
● LinesTrunks → PRI → B–ChannlGrp → Copy Number
Continued on next page
348
Primary Rate Interface (PRI)