Instruction manual

Features
A multiline telephone user can access the Loudspeaker Paging equipment and
make an announcement via Loudspeaker Paging in the following ways:
Selecting a line button programmed for the line jack on which the
Loudspeaker Paging system is connected
Selecting an SA button and dialing the pool dial-out code for the
Loudspeaker Paging port
Selecting an SA or ICOM button (either by pressing a Pickup button
programmed specifically for the paging port or pressing the Feature
button), and then dialing 9 followed by the paging port’s line number
(801-880)
Selecting Loudspeaker Page from the display (MLX display
telephones only) and dialing the line number (801-880)
Once the Loudspeaker Paging system is accessed, the user dials the assigned
code number for the paging area, if required by the Loudspeaker Paging
system, and speaks into the handset.
Single-Line Telephones
Single-line telephones cannot receive pages, even if they have a speakerphone.
Consequently, they cannot be included as members of a Speakerphone Paging
Group.
Single-line telephones cannot be used to make voice-announced inside calls
(Speakerphone Paging directed to an individual telephone). To direct
Speakerphone Paging to a group of telephones or to all telephones by using
Page All, the single-line telephone user lifts the handset and (while listening to
inside dial tone) dials the extension for the paging group or Page All group, and
speaks into the handset.
To use Loudspeaker Paging, the single-line telephone user lifts the handset and
(while listening to inside dial tone) dials #9 (Pickup) and then the paging port’s
line number, and speaks into the handset. The paging port is normally not
assigned to a single-line telephone.
320 Paging