Instruction manual
Features
Night Service
Paging
Park
Personal Lines
Power Failure
Transfer
Privacy
Ringing/Idle Line
Preference
Ringing Options
Saved Number
Dial
Signaling
SMDR
An MFM can be a member of a Night Service group. An
external alert connected to the MFM in the SAA operation, when
assigned to a Night Service group, can be used for
supplemental ringing for after-hours calls.
An MFM should not be a member of a Speakerphone Paging
Group.
An MFM user cannot park a call but can pick up a call parked
by another user.
When Personal Lines are assigned or removed from the
associated MLX telephone, they should also be removed from
the MFM when the device connected is used to answer calls or
provide supplementary ringing.
As a general rule, Personal Lines should be removed from
MFMs unless the device connected (such as a fax or a single-
line telephone) requires a Personal Line on which to make an
outside call.
A single-line telephone connected to an MFM cannot be used
for Power Failure Transfer.
The use of Privacy is not recommended for MFMs because the
user does not have an LED that indicates when the feature is
active.
Ringing/idle Line Preference should be turned on for an MFM.
The ringing patterns for tip/ring devices connected to an MFM
are those of an MLX telephone rather than a single-line
telephone-one ring for inside calls, two rings for outside calls
and three rings for priority ring or transfer return. Personalized
ringing patterns cannot be programmed for an MFM.
Centralized telephone programming must be used to program
Ringing Options (Immediate Ring, Delay Ring, or No Ring).
Saved Number Dial cannot be used on an MFM.
When set for SAA operation, an MFM can receive a manual
signal but cannot send one. An MFM cannot receive a manual
signal when set for tip/ring operation.
An MFM is treated as an MLX telephone on SMDR reports. The
system waits until the end of dialing before sending a connect
message to the MFM, and any digits dialed after the connect
message is received are not recorded on SMDR reports.
302 Multi-Function Module