Instruction manual

Features
■ Delay Ring and Coverage Delay Ring
The user can change these values by positioning the cursor on the
appropriate field and entering a new value. The range for Delay Ring is
1 to 6 rings; the range for Coverage Delay Ring is 1 to 9 rings.
The combined total of these two values should be less than either the
VMS Transfer Return Interval or the Transfer Return Time. This ensures
that a transferred call will always ring at a Coverage point before the
applicable return timer expires and the call either is transferred to the
alternative destination (in the case of a transfer from AUDIX Voice Power)
or returns to the transfer originator (in the case of a transfer from any
other extension).
■ VMS Transfer Return Interval and Transfer Return Time
The user can change these values by positioning the cursor on the
appropriate field and entering a new value. The range for both timers is
0 (transferred calls are never returned or redirected) to 9 rings.
The VMS Transfer Return Interval governs how long a call transferred
from an AUDIX Voice Power port will ring before it is redirected; the
Transfer Return Time governs how long a call transferred from any other
extension will ring before it returns to the transfer originator.
Each of these values should be greater than the combined total of the
Delay Ring and Coverage Delay Ring values. This ensures that a
transferred call will always ring at a Coverage point before the applicable
return timer expires and the call either is transferred to the alternative
destination (in the case of a transfer from AUDIX Voice Power) or returns
to the transfer originator (in the case of a transfer from any other
extension).
Switch Programming Results
The following information is sent to the switch:
■ Reliable Disconnect setting.
■ Delay Ring value.
■ Coverage Delay Ring value.
■ VMS Transfer Return Interval.
■ Transfer Return Time.
Screen Results
When the user finishes with the Application Switch Defaults screen and presses
[F3] (Save), the Technician Maintenance menu returns.
Extension Directory Setup
When the technician selects Extension Directory Setup from the
Technician Maintenance menu during installation, IS-III checks whether the
switch extension directory already exists in the application database. If the
directory does not exist, IS-III reads the switch extensions into the database,
244
Integrated Administration