Instruction manual

Features
If a user inspects a line that someone else is using, the display shows that the
line is in use.
If Inspect is activated and someone makes a voice-announced call or a Group
Page to the user, the Inspect feature is canceled and the Home screen is
displayed.
If the user presses the Feature, Menu, or Home button while Inspect is
activated, Inspect is canceled.
If a user is active on a call while using Inspect and presses a feature button, for
example, the Hold, Transfer, or Drop button, the system cancels Inspect and
attempts to activate the feature.
Telephone Differences
Direct-Line Consoles
Inspect cannot be used on analog Direct-Line Consoles (DLCs).
Queued Call Consoles
When a conference participant joins a conference by using a shared Personal
Line or Shared SA button, the QCC display is updated to include this
participant. However, if the QCC operator uses the Inspect feature to verify the
number of participants, the number shown on the display does not include
participants joining the conference on the Shared SA or Personal Line button.
If a QCC operator presses any of the buttons programmed with fixed QCC
features (for example, a Call, Start, or Source, button) while in the Inspect
mode, the console remains in Inspect mode. However, if the operator presses
the Feature, Transfer, HFAI, Conf, Mute, Drop, Speaker, or Hold button, the
console is removed from the Inspect mode.
Other Multiline Telephones
Inspect is available only on MLX display telephones.
Single-Line Telephones
Inspect cannot be used on single-line telephones.
Inspect 231