Instruction manual

Features
Transfer
The Transfer option of One-Touch Hold applies only to outside
calls on a DLC and not to calls on a QCC. When One-Touch
Hold is programmed, if a system operator presses a DSS button
with an inside caller on the line or, in Hybrid/PBX mode, with an
outside caller on an SA button, the call is not put on hold and a
manual signal is sent to the extension corresponding to the DSS
button pressed. When One-Touch Transfer (with either manual
or automatic completion) is programmed and the operator
presses the DSS button while the caller is on the line and no SA
or ICOM button is available on which to transfer the call, the call
does not go on hold. If the system operator hangs up, the caller
is disconnected.
Transfer is always initiated and Transfer completion is manual
when a system operator presses the DSS button corresponding
to a trunk number, pool dial-out code (Hybrid/PBX only), or ARS
access code (Hybrid/PBX only), even if One-Touch Hold, One-
Touch Transfer with automatic completion (DLC only), or
automatic extended call completion (QCC only) is programmed
for the system.
When a system operator transfers an Individual or Group
Coverage call and the call returns, the red LED next to the DSS
button for the sender does not flash as it does for a transfer
return for calls received on other types of line buttons.
When a system operator transfers a call to a Calling Group and
the call returns, the red LED associated with the Calling Group
does not flash as it does for a transfer return for user’s
extensions.
Direct Station Selector—MLX 145