Instruction manual

Features
Mode Differences
Behind Switch Mode
In the Behind Switch Mode, DSS buttons for system operator call Park Zones
are not operable.
Feature Interactions
Automatic Route
Selection
Barge-In
Camp-On
Display
Do Not Disturb
Extension Status
Forward and
Follow Me
The LED next to a DSS button for the ARS code is always off.
Barge-In can be activated by pressing a programmed Barge-In
button after making a call to the user’s extension by using a
DSS button.
When Camp-On is used to complete a call transfer and the call
returns, the DSS button for the extension where the call was
transferred goes off and does not flash as it does for a transfer
return or park return.
When the user presses a DSS button representing an extension
number, the extension number is shown on the display while
being dialed. When the Page button is pressed after pressing
the Inspect button, the display shows Page, the page number
selected, and the first extension number in the range. When the
user presses the Message Status button, the display shows
Message Status to indicate that the DSS is in the Message
Status operation.
In a Release 2.0 (or later) system, an operator can check the
status of an extension whose red LED is on by using the
Inspect button to determine whether the extension is busy or
using Do Not Disturb. If the user at the extension has turned on
Do Not Disturb, the Do Not Disturb message is also posted and
appears on the operator’s display. (However, the message may
also mean that the user has posted the message without turning
on the Do Not Disturb feature.)
A Calling Group or CMS supervisor or an operator at a DLC with
Extension Status assigned can change the status of a group
member or room by pressing a programmed Available or
Unavailable Extension Status button and then pressing the
DSS button for the group member or room.
Forward can be activated by pressing a programmed button or
using a feature code and then pressing a DSS button for the
extension where you want calls to go. Follow Me can be
activated by using the feature code and then pressing a DSS
button corresponding to the sending user’s extension number.
142 Direct Station Selector—MLX