Instruction manual
Table Of Contents
- Table of Contents
- About This Guide
- 1. Overview
- 2. Changing System Parameters
- Changing MERLIN MAIL—ML Port Allocation
- Changing the Delayed Answer Setting
- Adding, Changing, or Deleting a Fax Extension
- Changing the System Operator Extension
- Changing the General Mailbox Owner
- Changing the System Administrator’s Voice Mailbox
- Changing the Maximum Number of Digits in an Extension
- Changing the MERLIN MAIL—ML Language Selection
- 3. Changing the Schedule
- 4. Changing the Automated Attendant Menus
- 5. Adding and Changing Voice Mailbox Assignments
- 6. Creating, Changing, and Using Group Lists
- 7. Changing System Greetings
- 8. Troubleshooting
- A. MERLIN MAIL—ML Factory Settings
- B. Sending Faxes to the MERLIN MAIL—ML System
- Glossary
- Index
- Forwarding General Mailbox Messages
- Outcalling Administration
Changing the Automated Attendant Menus
4. [ 3 ] to program a submenu.
The Submenu Administration Menu plays.
5. [ 6 ] to modify a submenu.
The system prompts you to enter a submenu number and [ # ].
6. Enter the submenu number followed by [ # ].
The system prompts you to enter a Selector Code.
7. Enter a Selector Code ([ 1 ] through [ 9 ]).
If the Selector Code is already assigned, the system plays the Selector Code
definition and a prompt asking if you want to make a modification. Go to
Step 8.
If the Selector Code is not already assigned, the Selector Code Menu plays.
Skip to Step 9.
8. Choose an option:
— [ 9 ] for “Yes” to confirm that you want to modify it.
The Selector Code Modification Menu plays. Go to Step 9.
— [ 6 ] for “No” to cancel the modification.
The system prompts you to enter a Selector Code. Go back to Step 7.
4-24
Creating and Changing Submenus