Instruction manual

MERLIN LEGEND Communications System Release 6.1
System Manager’s Guide 555-661-118
Issue 1
August 1998
Managing the System
Page 6-91Removing a CTI Link
6
o Follow the procedure in the preceding topic, “Busying-Out and Restoring
the MLX Module,” to restore service on the module where the CTI link is
located.
o When you have finished, file Form 2a with the rest of the planning forms.
o To install the server-related hardware associated with the link, contact your
Lucent Technologies representative.
Programming Instructions 6
Removing a CTI Link 6
Use this procedure to remove the programming for a CTI (Computer Telephony
Integration) link from an MLX port on a 008 or 408 MLX module. This
hardware/software feature is available in Release 5.0 and later systems operating
in Hybrid/PBX mode.
NOTE:
This topic describes only the last steps in adding a CTI link to the system.
Additional LAN-related procedures are described in the
PassageWay
Telephony Services Network Manager’s Guide.
Task List: Removing a CTI Link 6
o Obtain Form 2a, System Numbering: Extension Jacks.
o Record the new values on Form 2a.
o If necessary, read “Auxiliary Equipment” in System Programming ,
Chapter 3, for additional information.
o Open the System Programming menu from the console or a PC with SPM.
o Follow the procedure outlined in “Busying-Out and Restoring the MLX
Module” on page 6–89 to terminate service on the module where the CTI
link is located.
o Program the change(s), following the appropriate instructions for “Auxiliary
Equipment” in
System Programming , Chapter 3, or the appropriate
summary programming instructions below.
o Follow the procedure outlined in “Busying-Out and Restoring the MLX
Module” on page 6–89 to restore service on the module where the CTI link
was located.
Console Procedure
$X[(TXLS→&7,/LQN→([WHQVLRQ→Dial ext. no.→
(QWHU→([LW→([LW
PC Procedure

→→→Type ext. no.→→→