Installation guide

3 Slide the T/P switch to T and hold it there.

All the red and green lights on the voice terminal begin to flash, and a

tone sounds.

If the lights do not flash:

Do This

Then

A. Check the green the green power light is go to B.

power light on the con-

trol unit.

the green power light is

make sure the

off

power cord is

plugged into the ac

outlet. Then set the

power switch on the

control unit to Off

and back again to

On. If the green

power light still does

not go on, contact

your equipment sup-

plier for assistance

before continuing

with the installation.

B. Check the wiring run

the wiring connections

make a note of the

from the control unit to

are stable problem, and refer

the voice terminal.

to the

Troubleshooting

Table, page 33, after

you’ve completed

the installation.

you find one or more

fix the connections.

loose connections

If the voice terminal

lights still do not

flash, make a note

of it, and refer to the

Troubleshooting

Table, page 33, after

you’ve completed

the installation.