Installation guide

CIB 2855
(11A) 10-BUTTON VOICE TERMINAL ADJUSTABLE DESK STAND (32002)
This desk stand is an adjustable
mounting base for the 7103
and 7303 Voice Terminals and
provides three angular posi-
tions: 8-degree (low), 18-degree
(middle), and 28-degree (high).
3.
4.
Gently slide the stand up-
ward so that the voice ter-
minal tabs fit firmly into
the smaller part of the
three mounting slots (see
Figure 2).
INSTALLATION INSTRUCTIONS
Note:
To avoid pinching
your fingers, make
certain the adjusta-
ble portion of the
desk stand is in the
lowest position be-
fore attempting to
install the voice ter-
minal.
1.
2.
Set the handset to one side
and turn the voice terminal
over.
Figure 2
Position the stand on the
back of the voice terminal
so that the voice terminal
mounting tabs fit into the
mounting slots on the
stand (see Figure 1).
The angle of the stand can
be adjusted (see Figure 3)
by performing the following:
VOICE TERMINAL
VOICE TERMINAL
MOUNTING SLOTS
MOUNTING TABS
11A Stand (Top View) 10-Button Voice Terminal
(Bottom View)
●
Use the forefinger of
your left hand to hold
the back of the stand
firmly to the desk top.
To RAISE — Using the
right hand, slowly lift the
rear of the voice terminal
until a desired position is
reached.
To LOWER — Using the
right hand, lift the rear
of the voice terminal to
release the locking ten-
sion. With the thumb of
your left hand, carefully
depress the side lever
and allow the stand to
lower to a desired posi-
tion.
Figure 3
REMOVAL INSTRUCTIONS
To remove the stand from the
10-Button Voice Terminal, slide
the stand out of the mounting
tabs by pushing the voice ter-
minal upward.
Figure 1
Equipment manufactured by AT&T Technologies in the U.S.A.