Installation guide

CIB 2852
(7302 H01) 5-BUTTON VOICE TERMINAL (3160)
4.
5.
1.
●
Press this ridge with your finger
while cupping the rail in the palm of
your hand; pull up to remove the rail
(see Figure 4).
The 5-Button Voice Terminal provides ac-
cess to intercom and outside lines, and to
programmable and other button features
shown in Figure 1 which may be provided
in your communications system.
Mount the voice terminal on the desk
stand or wall mount.
To convert the 5-Button Voice Terminal
from a desk terminal to a wall-mounted
terminal, follow the instructions packed
with the wall mount (CIB 2885).
INDICATOR
LIGHTS
HANDSET
SPEAKER
SPEAKER/RINGING AND TEST
CONTROL
RAIL
(TOP)
LABEL TAB
Test/Program (T/P) Control
The T/P switch is located on the left side
of the voice terminal (see Figure 3). It has
three positions: T (spring loaded and must
be held in the T position), center (indicated
by a “dot”), and the P position. It is set to
the center position for normal operation of
the voice terminal. After connection to the
control unit, the voice terminal can be put
into the test mode by holding the switch in
the T position. The voice terminal can be
put into the program mode by placing the
switch in the P position.
Speaker/Ring Volume Control
Figure 4
Figure 1
The volume control is located on the left
side of the voice terminal (see Figure 3).
Sliding the switch away from you increases
the volume while sliding it toward you de-
creases the volume.
Remove the label by pulling the end of
the label. (see Figure 5).
ASSEMBLING YOUR VOICE
Note:
The volume control changes the
volume of alerting rings, speaker,
and button clicks.
TERMINAL
1.
2.
3.
Unpack voice terminal and coiled hand-
set cord.
Turn voice terminal upside down and
plug one end of handset cord into jack
labeled with the drawing of the handset
beside it (see Figure 2).
Warning:
Do not plug the handset
cord into the jack labeled
“LINE”.
Plug the loose end of the handset cord
TEST/PROGRAM
SPEAKER/RING
SWITCH VOLUME CONTROL
T
TOP
VIEW
P
TOP
VIEW
into the handset (see Figure 2).
Figure 5
DEPRESS HERE
TO REMOVE RAIL
DEPRESS TO
REMOVE STAND
HANDSET
'LINE'
JACK
HANDSET
CORD
Labels may now be typed or handwrit-
ten in pencil or ink, and can be erased
(if necessary). Be sure the ink is dry
before inserting label.
Figure 3
REMOVING AND REPLACING
LABELS
The labels on five of the buttons on your
voice terminal can be changed.
Removal
To remove the voice terminal rail (lo-
cated above the touch-sensitive but-
tons):
●
Place your index finger at the center
of the rail; slide your finger beneath
the set until you feel the ridge im-
mediately in back of the rail.
Replacing
Insert the bottom of the label into the
label slot above the column of touch-
sensitive buttons.
Slide the label all the way into the slot
until the desired typed label appears
next to the proper button. (Note that
the label slides into the slot and behind
a thin top graphics overlay.)
Replace the rail.
2.
3.
1.
2.
3.
Equipment manufactured by AT&T Technologies in the U.S.A.
Figure 2