Installation guide

SIDE B
USING THE WALL MOUNTING KIT WITH THE ALUMINUM BRACKETS
NOTE:
The instructions below pertain to you if your kit contains three aluminum brackets.
If your wall mounting kit contains a black plastic backplate, please refer to the
instructions on Side A.
Choose the location for your control unit according to the instructions in your
Installation Guide: Models 206 and 410. To mount your control unit on the wall, follow
these instructions:
1. Make sure your mounting location is as large as the paper template included with
the three aluminum mounting brackets (Figure 1).
mounting holes
template
mounting brackets
self-tapping
screws
Figure 1
2.
3.
4.
5.
6.
7.
Hold the template up to the location, making sure the template is level. Mark
where the three mounting holes should go, using either a pencil or a sharp object.
You may then discard the template.
If you are mounting the brackets on plywood or sheet metal, drill three 9/64-inch
holes. The aluminum brackets will also work with 3/16-inch toggle bolts on dry
walls and #8 masonry anchors on concrete. (These may be purchased from a
hardware store.)
Position the brackets over the holes and insert the self-tapping screws.
Tighten the screws to securely attach the aluminum brackets to the surface.
Position the control unit against the three mounting brackets so the hooks on the
mounting brackets fit into the three slots in the back of the control unit.
Gently slide the control unit straight down so the hooks fit into the top part of the
slots.