Installation guide

SIDE A USING THE WALL MOUNTING KIT WITH THE PLASTIC MOUNTING
BRACKET
NOTE:
The instructions below pertain to you if your kit contains a plastic mounting
bracket. If your wall mounting kit contains three aluminum brackets, please refer
to the instructions on Side B.
Choose the location for your control unit according to the instructions in your
Installation Guide: Models 206 and 410. To mount your control unit on the wall, follow
these instructions:
1.
2.
3.
4.
5.
6.
7.
Make sure your mounting location is as large as the paper template included with
the black mounting bracket (Figure 1). The control unit is the size of the
template; the mounting bracket is smaller, as indicated by the dotted lines on the
template.
mounting holes
template
tabs
mounting
bracket
self-tapping
screws
Figure 1
Hold the template up to the location, making sure the template is level. Mark
where the two mounting holes should go, using either a pencil or a sharp object.
You may then discard the template.
If you are mounting the bracket on plywood or sheet metal, drill two 9/64-inch
holes. For plasterboard or wood paneling, drill two 3/16-inch holes.
Position the bracket over the holes and insert the self-tapping screws.
Tighten the screws to securely attach the mounting bracket to the surface.
Position the control unit against the mounting bracket so the tabs on the mounting
bracket fit into the slots in the back of the control unit.
Gently slide the control unit straight down so the tabs fit into the top part of the
slots.