Installation guide

Peel off backing and place label around switches as
shown in Figure 3 or 4 as applicable. Press firmly to
ensure adherence.
Important:
If you have just installed Feature Package 2
for the first time, you should do a system
reset to clear memory before programming
any of the features.
CLEAR (RESET) FEATURE PACKAGE MEMORY
8.
9.
10.
11.
12.
13.
14.
15.
16.
Set control unit in Administration Mode by setting
NORMAL/ADMIN switch to ADMIN position.
At voice terminal with intercom number 0 (Model 206)
and intercom number 10 (Models 410 and 820) set the
T/P switch to P (program) position.
Dial #01 on this voice terminal.
At the control unit, set NORMAL/ADMIN switch to
NORMAL position.
At voice terminal intercom number 0 (Model 206) or 10
(Models 410 and 820), dial ✼ 99. You will hear two
short tones.
At the control unit, turn power off, then on.
At voice terminal, set T/P switch to center (normal
position).
FEATURE PACKAGE MEMORY CLEARED
Close control unit door.
Note:
Feature Package 2 User’s Guides, Administrator
Manual, and the two sets of Feature Package 2
Voice Terminal Labels for Intercom Extension 0
(Administrator) are included with the Feature
Package 2. All voice terminal users should be
advised that their system is now equipped with
Feature Package 2. Their voie terminal should be
programmed per instructions in the Feature
Package 2 User’s Guide and Administration
Manual.
Feature Package 2
Voice Terminal Labels For
Intercom Extension 0 (Administrator)
Figure 5. Feature Package 2 Voice Terminal
Labels (One-Fourth Actual Size)
Instructions For
(Z111A) FEATURE PACKAGE 2
CARTRIDGE TYPE I (6104)
CIB 3011
ISSUE 1
Copyright © 1984 AT&T Technologies
All rights reserved