Installation guide

CIB 3011
(Z111A) FEATURE PACKAGE 2 CARTRIDGE TYPE I (6104)
This Feature Package 2 Cartridge (Figure 1) can be installed
in your Communications System Control Unit Models 206,
410, and 820. When installed, custom features can be
programmed into your system to expand system capabilities.
A. MODELS 206/410
B. MODEL 820
Figure 1
Included in the package with the cartridge are:
- Feature Package 2 User’s Guides
●
●
●
●
●
10
1 -
1 -
1 -
2 -
Feature Package 2 Administration Manual
Switches label for Model 206 (Figure 3)
Switches label for Model 410 (Figure 4)
Feature Package 2 — Voice Terminal Labels for Inter-
com Extension 0 (Administrator) (Figure 5)
INSTALLATION
1.
2.
Open control unit door.
Disconnect control unit power cord from its ac outlet or,
on Model 820, set Power Switch to off; and if the
auxiliary power supply is installed, disconnect the power
cord.
3.
4.
5.
6.
7.
Warning:
Removing or inserting cartridges in control unit
with power on
could cause damage to system
circuits.
At upper right of control unit (see Figure 2), find Cartridge
Type I slot, and, if occupied with a cartridge, remove car-
tridge; otherwise, remove plastic cover.
Note:
Model 820 has an ejection lever for removing and
installing cartridges.
Carefully slide the Feature Package 2 Cartridge into Car-
tridge Type I slot and seat firmly. (On Model 820 close ejec-
tor lever.)
Reconnect the auxiliary power supply, if applicable (Step
2).
Reconnect power cord to ac outlet, or on Model 820, set
power switch to ON.
Note:
When power is applied, the red lamp on the
control unit should light momentary and go off.
The green lamp should light and remain on.
For Model 206 or Model 410, get appropriate switch
label supplied in cartridge package (Figure 3 or 4) as
applicable.
Figure 2
Figure 3. Model 206 Control Unit Switches Label
Figure 4. Model 410 Control Unit Switches Label
Equipment Manufactured by AT&T Technologies in U.S.A.