Installation guide

TEMPLATE
WALL MOUNTING KIT
INSTALLATION INSTRUCTIONS
1.
2.
3.
4.
Choose a location for your control unit according to the
instructions in your installation manual.
Hold the template up to the location; make sure it is
level; then mark where the two mounting holes should go.
(pierce the center of the holes with a small nail or
equivalent).
If you are mounting the bracket on:
● PLYWOOD or SHEET METAL, drill two 9/64-inch holes.
● PLASTERBOARD or WOODPANELING, drill two 3/16-inch holes
(it is recommended that you use expansion bolts to
secure the bracket).
Fasten the bracket to the wall.