Installation guide

CIB 3002
(Z200A) 2–LINE/5–VOICE TERMINAL MODULE FOR MODEL 820 (61219)
This module (Figure 1) is used to expand
the capacity of your Model 820 control
unit. Addition of this module wiII enable you
to have two more outside lines and five
voice terminals. Each module comes
packed with two line cords (7-foot) and a
267C (two-line) adapter.
CONTROL UNIT
POWER
SWITCH
AUXILIARY
POWER CORD
Figure 3
2–LINE/
5–TERMINAL
FACEPLATE
EXPANSION
MODULE
Figure 5
2.
Locate the leftmost available expansion
module slot.
Grasp the handle on the faceplate of
the expansion module slot and pull it
open (see Figure 4). Do not remove
the faceplate.
3.
Close the faceplate.
Install the line cords (7-foot) and termi-
nal cords (2-1/2 foot). Arrange the
cords underneath the control unit.
LOCKING TAB
Repeat Steps 2 through 6 if installing a
second expansion module.
EXPANSION
MODULE
SLOTS
Z6C DOOR
HANDLE
FACEPLATE
5.
6.
7.
8.
9.
Figure 1
1.
Open and remove the control unit door
(see Figure 2).
Reconnect the auxiliary power cord
back to the control unit and switch the
control unit power back on.
Note:
When you apply ac power, the
red warning light on the control
unit should come on momen-
tarily and then go off. The
green light should come on and
stay on.
Reinstall the control unit door.
Figure 2
Warning:
Switch off the control unit
power. If you have an auxil-
iary power supply, unplug
the auxiliary power cord
from the control unit (Fig-
ure 3) before inserting this
module.
Figure 4
4.
Slide the module slowly and steadily
into the slot (Figure 5) until it is prop-
erly seated.
Equipment manufactured by AT&T Technologies in the U.S.A.