Installation guide

5.
6.
7.
8.
Method B. At the network interface jack with
two-line appearances, plug a Two-
Line Adapter (267C) into the line
jack. Plug the Line Bridging adapter
(267A2) into the line jack of the
two-line adapter that is to have
remote ringing.
Insert the plug end of a Line Extension Cord
(D4CE-50) into one jack on the line bridging
adapter.
Plug one end of a Modular Line Cord (D4CH)
into the jack end of the Line Extension Cord
(D4CE-50) and plug the other end of the cord
into the LINE jack on the ringer.
Plug one end of another Modular Line Cord
(D4CH) into the unoccupied jack on the line
bridging adapter and plug the other end into the
appropriate Tel. Co. Lines jack on the control
unit.
Test and Adjust Ringing
Place a call to the line number with the ringer
installed. When ringing occurs, adjust the volume
control lever for the desired loudness.
Instructions For
D181233 Line-Powered
Extra-Alert E1CM Ringer
and Parts (61211)
CIB 2924
ISSUE 1
Copyright © 1984 AT&T Technologies
All rights reserved
Equipment manufactured by AT&T Technologies in the U.S.A.