Installation guide

CIB 2887
(203A) 34-BUTTON VOICE TERMINAL WALL MOUNT (32006)
This bracket is used to mount 7205, 7305,
and 7405 Voice Terminals on a wall sur-
face.
INSTALLATION INSTRUCTIONS
Note:
Be sure to select a location for
installation at least as large as
the voice terminal; the wall
mounting is slightly smaller
than the terminal itself.
Select the wall mounting location; using
the wall mount as a template, mark
the four mounting hole locations (two
upper slots and two lower holes (see
Figure 1).
8.
9.
10.
11.
SWITCHHOOK
BUTTON
NUMBER
STRIP
RETAINER
PAPER CLIP
VOICE TERMINAL
MOUNTING SLOTS
MOUNTING
MOUNTING
SCREW SLOT SCREW SLOT
MOUNTING MOUNTING
SCREW HOLE SCREW HOLE
VOICE TERMINAL
MOUNTING SLOTS
A
B
C
RED D
KEY
WALL
MOUNT
E
WALL MOUNT
MOUNTING
SLOTS
TWO LOWER
MOUNTING
HOLES
NUMBER STRIP
3
(EXAMPLE)
HANDSET
RETAINER
HANDSET
RETAINER
SCREW
1.
2.
3.
4.
5.
6.
7.
Figure 1
Select proper toggler for wall thickness
or wall type:
●
●
●
For walls 3/8- to 1/2-inch thick,
select the smaller of the two sizes
provided.
For walls 5/8- to 3/4-inch thick,
select the larger of the two sizes
provided.
For solid walls, either of the two
●
●
●
●
●
●
●
HANDSET
RETAINER
REMOVED
ROTATE
HANDSET
TO WALL
RETAINER
MOUNT
SCREW
POSITION
REMOVED
sizes may be used.
Drill four holes at the four toggler
mounting locations, using a 5/16-inch
diameter drill.
Fold toggler (see Figure 2A).
Insert a toggler in each of the mount-
ing locations, and tap each toggler
flush to wall (see Figure 2B).
Pop the anchor open with the red key
— do not hammer the key (see Fig-
ure 2C).
Insert and partly thread the top two
screws into the starter holes of the
togglers (see Figure 2D).
Position the two upper mounting slots
onto the screws and slightly tighten
(see Figure 2E).
Insert the two remaining screws into
the lower mounting holes (see Figure
2E).
Tighten all four screws securely.
Figure 3
Figure 2
Convert the 34-Button Voice Terminal
from a desk terminal to a wall-
mounted terminal by following the
substeps below:
Remove the desk stand.
Remove the number card retainer
and the number card (see Figures
3 and 4).
Remove the screw under the num-
ber card and lift out the handset
retainer from the upper housing
(see Figure 5).
Rotate the handset retainer 180
degrees end-over-end (see Figure
6).
Replace the handset retainer into
upper housing. If properly inserted,
a portion of the handset retainer
should be projecting into the hand-
set well of the upper housing (see
Figure 7).
HANDSET
HANDSET
RETAINER
RETAINER
IN WALL
AFTER
MOUNT
ROTATION
POSITION
HANDSET
HANDSET
RETAINER RETAINER
SCREW
SCREW
Replace screw.
Replace number card and number
card retainer.
Figure 4
Figure 5
Figure 6
Figure 7