Installation guide

CIB 2886
(11C) 34-BUTTON VOICE TERMINAL ADJUSTABLE DESK STAND (32003)
This desk stand is an adjustable
mounting base for the 7205,
7305, and 7405 Voice Termi-
nals and provides three angular
positions: 8-degree (low), 18-
degree (middle), and 28-degree
(high).
3.
4.
INSTALLATION INSTRUCTIONS
Note:
To avoid pinching
your fingers, make
certain the adjusta-
ble portion of the
desk stand is in the
lowest position be-
fore attempting to
install the voice ter-
minal.
1.
2.
Set the handset to one side
and turn the voice terminal
over.
Position the stand on the
back (or bottom) of the
voice terminal so that the
voice terminal mounting
tabs fit into the “A”
mounting slots on the
stand (see Figure 1).
Gently slide the stand up-
ward so that the voice ter-
minal tabs fit firmly into
the smaller part of the
three mounting slots (see
Figure 2).
Figure 2
The angle of the stand can
To LOWER — Using the
right hand, lift the rear
of the voice terminal to
release the locking ten-
sion. With the thumb of
your left hand, carefully
depress the side lever
and allow the stand to
lower to a desired posi-
tion.
Figure 3
REMOVAL INSTRUCTIONS
"A" MOUNTING
THREE VOICE TERMINAL
SLOTS
MOUNTING TABS
"B" MOUNTING
SLOTS
34-BUTTON VOICE TERMINAL
(BACK VIEW)
be adjusted (see Figure 3)
by performing the following:
To remove the stand from the
34-Button Voice Terminal, slide
●
Use the forefinger of
the stand out of the mounting
your left hand to hold
tabs by pushing the voice ter-
the back of the stand
minal upward.
firmly to the desk top.
To RAISE — Using the
right hand, slowly lift
the rear of the voice
terminal until a desired
position is reached.
Figure 1
Equipment manufactured by AT&T Technologies in the U.S.A.