Installation guide

10.
Convert the 5-Button Voice Terminal
from a desk terminal to a wall-
mounted terminal by following these
steps:
HANDSET
HANDSET
RETAINER
RETAINER
IN WALL
AFTER
MOUNT
ROTATION
POSITION
HANDSET
HANDSET
RETAINER
RETAINER
SCREW
SCREW
●
●
●
●
11.
12.
13.
●
●
Remove the number card retainer
and the number card (see Figure
6).
Remove the screw under the num-
ber card and lift out the handset
retainer from the upper housing
(see Figure 7).
Rotate the handset retainer 180
degrees end-over-end (see Figure
8).
Replace the handset retainer into
the upper housing. If properly in-
serted, a portion of the handset
retainer should be projecting into
the handset well of the upper
housing (see Figure 9).
Replace screw.
Replace number card and number
card retainer.
SWITCHHOOK
BUTTON
NUMBER
STRIP
RETAINER
PAPER CLIP
Figure 6
HANDSET
RETAINER
HANDSET
RETAINER
SCREW
Figure 7
Figure 9
Thread one end of the D8W Modular
Terminal Cord up through the cord
slot of the wall mount, and plug into
the jack labeled “LINE” on the back
of the voice terminal.
Position the back (or bottom) of the
voice terminal so the mounting slots
of the voice terminal fit just above the
wall mount’s mounting tabs.
Gently slide the voice terminal down
so the voice terminal tabs fit securely
in the three mounting slots (see Fig-
ure 10). Forward pressure must be
applied to the voice terminal so the
terminal’s locking tab is depressed.
Figure 10
Instructions For
14A 5-Button Voice
Terminal Fixed Desk Stand
and Wall Mount (32000)
HANDSET
RETAINER
REMOVED
HANDSET
ROTATE RETAINER
TO WALL SCREW
MOUNT
REMOVED
POSITION
CIB 2885
ISSUE 2
Figure 8
Copyright © 1984 AT&T Technologies
Equipment manufactured by AT&T Technologies in the U.S.A.
All rights reserved