Installation guide

CIB 2865
(7305 H01) 34-BUTTON VOICE TERMINAL (3162)
The 34-Button Voice Terminal provides ac-
cess to intercom and outside lines, and to
programmable and other button features
shown in Figure 1 which may be provided
in your communications system.
INDICATOR
SPEAKER
LIGHTS
HANDSET
1.
2.
Figure 1
ASSEMBLING YOUR VOICE
TERMINAL
1. Unpack voice terminal and coiled hand-
set cord.
2.
Turn voice terminal upside down and
plug one end of handset cord into jack
with the drawing of the handset beside
it (see Figure 2).
Warning:
Do not plug the handset
cord into the jacks labeled
“LINE” or “OTHER”.
3.
4.
5.
6.
Turn the voice terminal right side up.
REMOVING AND REPLACING
LABELS
Plug the loose end of the handset cord
into the handset (see Figure 2).
Removal
Position the voice terminal on the desk
1.
stand or wall mount.
To convert the 34-Button Voice Termi-
nal from a desk terminal to a wall-
2.
mounted terminal, follow the instruc-
tions packed with the wall mount (CIB
2887).
SPEAKER/RINGING AND TEST
CONTROL
Test/Program (T/P) Control
The T/P switch is located on the left side
of the voice terminal (see Figure 3). It has
three positions: T (spring loaded and must
be held in the T position), center (indicated
by a “dot”), and the P position. It is set to
the center position for normal operation of
the voice terminal. After connection to the
control unit, the voice terminal can be put
into the test mode by holding the switch in
the T position. The voice terminal can be
put into the program mode by placing the
switch in the P position.
Speaker/Ring Volume Control
The volume control is located on the left
side of the voice terminal (see Figure 3).
Sliding the switch away from you increases
the volume while sliding it toward you de-
creases the volume.
REMOVE TO PLUG IN
HANDS-FREE UNIT OR
OTHER ACCESSORY
"OTHER"
"LINE"
JACK
JACK
HANDSET
HANDSET
VOICE
CORD
TERMINAL
(BOTTOM
VIEW)
Note:
The volume control changes the
volume of alerting rings, speaker,
and button clicks.
Above the touch-sensitive buttons,
grasp the silver tab and pull the label
out of the label slot (see Figure 4).
Labels may now be typed or handwrit-
ten in pencil or ink and can be erased
(if necessary).
Replacing
Insert the bottom of the label into the
label slot above each column of the
touch-sensitive buttons.
Slide the label all the way into the slot
until the desired typed label appears
next to the proper button. (Note that
the label slides into the slot and behind
a thin top graphics overlay.)
Figure 4
TEST/PROGRAM
SPEAKER/RING
SWITCH
VOLUME CONTROL
T
TOP
P
VIEW
TOP
VIEW
Figure 2
Figure 3
Equipment manufactured by AT&T Technologies in the U.S.A.