Installation guide

CIB 2858
(103A) CUSTOMER-INSTALLABLE JACK (32601)
The customer-installable jack is
used to connect 4-pair DIW ca-
ble to a D8-type modular cord.
INSTALLATION INSTRUCTIONS
Remove the cover from
the customer-installable
jack by loosening the
screw (see Figure 1). Do
not remove the screw
from the cover. Set the
cover aside until the in-
stallation is complete.
MOUNTING
HOLES
CABLE
COVER
1/4 IN.
CABLE NOTCHES
SCREW
CAPS
CABLE NOTCHES
4.
cutters, near the plastic
CABLE NOTCHES
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
CAPS
WHITE-BLUE
BLUE
WHITE-ORANGE
ORANGE
WHITE-GREEN
GREEN
WHITE-BROWN
BROWN
CABLE NOTCHES
1.
2.
3.
Figure 1
Using the cable stripping
tool, or equivalent, re-
move 2 inches of the
cover from one end of an
8-conductor cable.
From beneath the cus-
tomer-installable jack
base, insert the wire ends
of the cable through the
hole in the center of the
base until about a quarter
of an inch of the cable
cover extends above the
hole (Figure 2).
6.
7.
caps, ensuring that the
wire ends are not touch-
ing each other (Figure 4).
Figure 2
Remove the two white
plastic caps by pulling
them away from the jack;
set them aside until Step
6.
8.
5.
Insert the wires in the
notches in the color se-
quence shown in Figure 3.
Figure 4
Align the cable in one of
the notches in the base of
the customer-installable
jack depending on the di-
rection you want the cable
to leave the block (Figure
4).
9.
Position the customer-in-
stallable jack and mount
with appropriate fasteners.
10.
Replace the cover on the
jack and tighten the
screw.
Figure 3
Replace each cap by
aligning it in position and
pressing tightly to make
electrical connections.
Cut off the loose wire
ends with scissors or wire
Equipment manufactured by AT&T Technologies in the U.S.A.