User`s guide

Troubleshooting
Symptom Possible Causes
Possible Solutions
After pressing
■ Battery is not charged
■ Place handset in charging
[ On/Off ], dial tone i S
sufficiently. cradle for 12 hours. Or, if
not heard and hand-
you have a fully charged
set display does not
(14 hours) spare battery,
show anything.
use it to replace the battery
in the handset.
■ Handset is out of range of ■ Move the handset closer
its matching radio module.
to the radio module.
■ Telephone line cord is not
■ Plug the telephone line
plugged into the radio cord into the radio module.
module.
After pressing [ On/Off ],
■ There is no battery in the ■ Insert battery in handset.
dial tone is not heard
handset.
and the
RADIO LED
on the radio module
■ Battery is not inserted ■ Make sure battery is inserted
does not light.
properly in handset. properly in handset.
■ Battery is not charged ■ Place handset in charging
sufficiently. cradle for 12 hours. Or, if
you have a fully charged
(14 hours) spare battery,
use it to replace the
battery in the handset.
■ Handset is out of range of
■ Move the handset closer
its matching radio module.
to the radio module.
■ There is interference from ■ Remove electrical device
another electrical device causing interference or move
(microwave) or metal walls.
handset to another location.
BATT appears in the Battery requires recharging.
You have 1-2 minutes of talk
handset display.
time left. Either:
■ Complete your call, turn the
handset off, and recharge
the battery (12 hours).
■ If you have a fully charged
(14 hours) spare battery,
place your call on Hold.
Swap the batteries. Wait 6
to 10 seconds, then turn the
handset on and proceed as
you would for any call
placed on Hold.
5