Specifications

Valid Entries
1 = Assigned ✔
2 = Not Assigned
3 = Select Button (then press a line button to assign the line to that button)
Programming
To assign lines to a specific extension:
1.
Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 3 ] [ 0 ] [ 1 ].
2.
Enter the extension number to be programmed (10–33). For example, to
program extension 15, press [ 1 ] [ 5 ].
The red light next to each button that has a line assigned is on steady. To
remove all existing line assignments, press [ Remove ] before selecting a line.
3.
Enter the line number (01–12) to be assigned. For example, to select line 1,
press [ 0 ] [ 1 ].
4.
At this point:
■ If you want to assign the line to the first available button with lights,
press [ Next Data ] until the display reads:
Line Assignment 15 L01
1 Assigned
■ If you want to remove a line assignment, press [ Next Data ] until a display
similar to the following appears:
Line Assignment 15 L01
2 Not Assigned
■ If you want to assign the line to a specific button, press [ 3 ]. A display
similar to the following appears:
Line Assignment 15 L01
3 Select a Button
Then press a button with lights to assign the line to that button. If you
use option 3 after a line has been assigned, the line moves from the old
button to the new button you select.
5.
At this point:
■ To program another line for this extension, press [ Next Item ] or [ Prev Item ]
until the line number shows on the display. Then repeat Step 4.
■ To program another extension, press [ Next Procedure ] [ Prev Procedure ] and
begin at Step 2.
6.
Select another procedure or exit programming mode.
Line Assignment (#301) 5-87