Cordless Telephone User Manual

Installation Procedure
Reconfigure the Boards If Necessary
Requirement: Be sure to take notes throughout this phase of
installation. Write down I/O addresses and the
memory addresses so that once the device drivers
have been installed you will have a permanent
record to which you may later refer. Likewise, if
you are going to remove or add a board, write
down any changes that you make in the process.
A sample configuration record is shown in
Appendix A.
Refer to Appendix A, “Hardware Parameter Settings,” for switch location
and decode information if it is necessary to change these settings to match the
software (driver) configuration established by the IPC16CNF program. Note
that Steps 5 through 7 (this discussion is Step 6) can be executed when
necessary to reconfigure the driver and/or port characteristics. The following
screen display shows the typical prompts associated with reconfiguration.
Re-Configure the IPC1600(s) (Y/*) : Y
Save Changes to Disk for Re-Boot? (Y/*) : Y
Quit? (Q/*) : Q
Re-boot to Load Driver
Reboot the System
Reboot the system (AT&T WGS computer) to load the Intelligent Ports
Card MS-DOS device driver.
2-14 IPC-1600 USER’S GUIDE