Instruction manual

Maintenance
Table 6-2. BRI Error Messages (Continued)
Code Description of Error
Possible Solution
3401
ENDPT IN RESTRICTED SVCE Usually caused by an incorrect SPID. Check
Service on the link has been lost.
the SPID and reprogram as necessary.
9403
LINK ESTABLISHMENT FAIL Check that the line is securely connected to
Service on the link has been lost.
the port and that the LEDs on the 800 CO-
BRI module show proper operation. If the
module is working properly, the line may not
have been activated by the CO.
9404
NW NOT RESPOND TO SETUP
The CO is not responding to messages sent
Service on the link has been lost.
by the MERLIN LEGEND system. Contact
the CO.
9405
NW NOT RESPOND TO RELEAS
The CO is not responding to messages sent
Service on the link has been lost.
by the MERLIN LEGEND system. Contact
the CO.
9406
NW TOOK ENDPOINT OOS
The CO has taken the endpoint out of
Service on the link has been lost.
service. Contact the CO.
9407
ENDPOINT UNINIT (L2,L3)
Caused when Layer 1 is up but Layer 2
Service on the link has been lost.
and/or 3 is down for an endpoint. If problem
persists, contact the NTSC.
Error Logs and Error Messages 6-25