91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 User Manual (Part 2) 5.
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd You must charge the battery and register the handset before use. STOP! 2/13/1950 7:21 PM See pages 2-5 for easy instructions. For customer service or product information, visit our web site at Please also read www.telephones.att.com or call 1-800-222-3111. Enclosed in product package. Important Product Information Table of contents Before you begin........................................1 Parts checklist........................................
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 1 Before you begin If you move out of range during a phone conversation, you might hear noise or interference. To improve reception, move closer to the base. This cordless telephone operates with the maximum power allowed by the Federal Communications Commission (FCC).
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 2 Battery & charger installation Installation of Battery pack in Handset Follow the step below: 1. Remove the battery compartment cover by pressing on the indentation and sliding downward. Place the new battery pack in the handset with the positive and negative poles aligned in the battery compartment. 2. Replace the battery cover by sliding it upwards. 3.
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 3 Registering the handset Base: Select MENU, then highlight DISPLAY BASE ID DIRECTORY MAILBOXES SETUP BASE DISPLAY BASE-ID ^ OK V Before using your new handset, you must register it with the EP5962 base. During registration, you must enter the 15-digit ID number of the telephone base. To find this number, go to the EP5962 base, select MENU, scroll down to highlight DISPLAY BASE ID, then select OK.
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 4 Replacing a handset If you are replacing a handset on a system that has the maximum number of registered handsets (8) or wish to change the assigned handset number of your registered handset, you must first deregister all handsets and then re-register all handsets. NOTE: Use this option with EXTREME CAUTION. It will make all handsets unusable until each one has been reregistered.
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 5 Re-Registering a handset You can re-register handsets after deregistration from the base. Or you can re-register handsets to a new base unit if you have replaced your base unit for any reason. During re-registration, you must enter the 15-digit ID number of the telephone base. To find this number, go to the base, select MENU, scroll down to DISPLAY BASE ID, then select OK.
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Belt clip & optional headset Install belt clip as shown below if desired. For hands-free telephone conversations, you can use any industry standard 2.5 mm headset (purchased separately). For best results use an AT&T 2.5 mm headset. Snap belt clip into notches on side of handset. Rotate and pull to remove. Plug 2.5 mm headset into jack on side of handset (beneath small rubber cap).
1-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 7 Quick reference guide For complete instructions, please refer to the manual provided with your EP5962 telephone. Off/Clear Softkeys Press a softkey to select an item displayed just above the key. During a call, press to hang up. While using menus, press to cancel an operation, back up to the previous menu, or exit the menu display. L1/Flash, L2/Flash Press LINE 1 to make or answer a call on line 1.
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 www.telephones.att.com Copyright © 2005 Advanced American Telephones. All Rights Reserved. AT&T and the Globe Design are trademarks of AT&T Corp., licensed to Advanced American Telephones. Printed in China. Issue 4 AT&T 09/05.
